triumph TR3-Rear Valance Work-Part 4

Yesterday I did another trial fit of the fabricated lower piece of the valance (and attached it temporarily to the car) and it fits well and looks good. Unfortunately the match up to the other patch panel (left hand side)was not as clean as I would like (to be expected as I fabricated the pieces separately and hadn't done a trial fit of the two pieces before) so I decided to remove it and do some minor trimming to see if I could get a better fit. Unfortunately it doesn't meet my standard for appearance (structurally it is sound) so through the process I decided I will probably reject the flange component (3rd time) I fabricated a few days ago and start again with a bit different approach. Rework.